Skip to content
TalleresAMG Mechanics · Electronics · Programming EspañolES

Programming and tuning

Control unit programming and tuning

We code, synchronise and tune engine control units. Stage 1 and Stage 1+: more response and power recovery in cars that have lost it. Before we write anything, we always dump your original file.

The button takes you to the enquiries and appointments form, where WhatsApp opens with the message already written.

Stage 1 and Stage 1+

We modify engine management maps using files.

Backup

Full content dump before writing, and verified writing afterwards.

Three ways

In the car, on the bench or with the board open.

What programming includes

A control unit is not just a chip: it is a set of files that have to match each other. If a single one is not programmed correctly, the car throws faults that have nothing to do with the original problem.

What we do

  • CodingWe set the unit up for the car it goes in: code, immobiliser and trim level.
  • SynchronisationWhen two units talk to each other, we make them talk properly. Especially immobiliser and engine unit.
  • Stage 1 tuningMore response, lower consumption and power recovery in cars that have lost it.
  • Stage 1+ tuningMore aggressive, for cars that take a bigger adjustment. We tell you if yours can take it.
  • Reading and writing filesFull content dump, verified writing and a copy of the original so you can go back.
  • Programming after a repairIf we repaired a board, we reprogram it so it does its job again.

When it is not worth repairing

We tell you before touching anything. If the part is too damaged, if it has been flooded with fresh water, or if there is nothing left to save, we will not make you spend money on a repair that will fail again. In that case we tell you what the new one costs and you decide.

How we do it

  1. Read everything

    We read the whole unit, not just one code. That way we see exactly what it has and what it is missing.

  2. Backup

    We dump your original file before touching anything. That file is your safety net.

  3. Write and verify

    We write and check it all landed. If the read-back does not match, you do not get the car like that.

  4. Fit and test

    We fit the unit and go out for a drive.

  5. Handed back with its copy

    You get the car with a copy of the file in case you ever need it.

Frequently asked questions

What is the difference between Stage 1 and Stage 1+?

Stage 1 is a conservative adjustment almost any car takes well. Stage 1+ is more aggressive and gives more, but it needs cooling, injectors or turbo in good condition. We tell you which one suits your car.

Can you not legally do Stage 2?

No. Homologation rules do not allow a Stage 2 modification for public roads. Stage 1 and Stage 1+ must be declared to the ITV and are for private use, circuits or enclosed venues only.

Do I lose the warranty if I tune it?

Programming the unit usually voids the manufacturer warranty, because it is a modification. If your car is still under warranty and you do not want to lose it, do not do it yet. We tell you before starting.

How long does it take?

Usually a few hours. If a part has to be ordered or a previous fault solved, we tell you first.

Shall we talk?

Get in touch

If you want a solution for your fault, contact us as soon as possible. Fill in the form, WhatsApp opens with the message already written and you just press send.

Fill in the enquiries and appointments form

Tell us what you need

Fill in the form and WhatsApp opens with the message already written. You just press send.

Programming enquiry

No commitment. We tell you what can be done and what it costs.

WhatsApp will open with the text already written. We do not store what you type.

If the form does not work, message us directly: WhatsApp Angel, 665 65 64 57 or call us.